Siemens SINUMERIK 828D Commissioning Manual page 550

Configuring cycles
7.9 Measuring cycles and measurement functions
SD54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH[n]
= 2
MD51752 $MNS_J_MEA_M_DIST_TOOL_LENGTH
= 2
MD51753 $MNS_J_MEA_M_DIST_TOOL_RADIUS
= 1
MD51786 $MNS_J_MEA_T_PROBE_MEASURE_DIST
= 10
General cycle setting data when measuring with rotating spindle
SD54670 $SNS_MEA_CM_MAX_PERI_SPEED[0]
= 100
SD54671 $SNS_MEA_CM_MAX_REVOLUTIONS[0]
= 1000
SD54672 $SNS_MEA_CM_MAX_FEEDRATE[0]
= 20
SD54673 SNS_MEA_CM_MIN_FEEDRATE[0]
= 1
182
Default value
Default value
Default value
Default value
Default value
Default value
Default value
Default value
Distance between the tool probe up‐
per edge and the milling tool lower
edge.
Measuring path to measure the tool
length.
Measuring path to measure the tool ra‐
dius.
Measuring path to calibrate the probe
or for measurements with stationary
spindle.
Maximum permissible peripheral
speed of the tool to be measured.
Maximum permissible tool speed of the
tool to be measured. The speed is au‐
tomatically reduced when exceeded.
Maximum permissible feedrate to
probe the tool to be measured at the
probe.
Minimum feedrate for the first probing
of the tool to be measured at the probe.
This avoids excessively small fee‐
drates for large tool radii.
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate