Siemens SINUMERIK 828D Commissioning Manual page 484

Configuring cycles
7.5 Turning
SD55582 $SCS_TURN_CONT_TRACE_ANGLE
= 5
SD55583 $SCS_TURN_CONT_VARIABLE_DEPTH
= 20
SD55584 $SCS_TURN_CONT_BLANK_OFFSET
= 1
SD55585 $SCS_TURN_CONT_INTERRUPT_TIME
= > 0
= < 0
= 0
Note
The channel-specific cycle setting data SD55585 is only evaluated if
SD55586 $SCS_TURN_CONT_INTER_RETRACTION = 0.
116
5 degree angle
20% variable cutting depth
1 mm or 1 inch blank allowance
Interruption time in seconds
Interruption time in revolutions
No interruption
The angle between cutting edge and con‐
tour as of which rounding is performed on
the contour during contour turning in order
to remove residual material.
If the angle of the residual material is greater
than that specified in the setting data, the
tool will round the contour.
Percentage of the changing cutting depth
when turning a contour
You can select changing the cutting depth
for stock removal and for removing residual
material.
Safety clearance when avoiding obstacles,
to avoid collisions during approach or retrac‐
tion from the machining.
This also applies to stock removal, grooving
and plunge turning.
Time for the feedrate interruption for contour
turning.
This also applies to stock removal, grooving
and plunge turning.
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate