Siemens SINUMERIK 828D Commissioning Manual page 577

● Clamping system
● Logistics data
Requirements
● A spindle with DQI encoder: r0459, bit 14 = 1.
● Drive telegram 139 is configured for the spindle.
● The spindle functionality for the machine axis is present when MD35000
$MA_SPIND_ASSIGN_TO_MACHAX > 0
The value corresponds to the spindle number.
References
For further information, please refer to the following documentation:
Basic Functions Function Manual: Spindles (S1)
Section "Spindle with SMI 24 (Weiss spindle)"
Data overview
The "S1 Spindle Diagnostics" window shows the following information:
Parameter
Operating hours
● Spindle under control
● Spindle under speed
Number of clamping cycles (tool change)
Definition of a clamping cycle: Released clamping state [3] → Clamped clamping state
[7, 8 or 10] → Released clamping state [3].
Motor temperature
Clamping state (sensor 1)
Piston free (sensor 4)
E.g. defined rotary angular position of the shaft (sensor 5)
Maximum speed
Procedure
1. Select the "Diagnostics" operating area.
2. Press the menu forward key.
3. Press the "Spindle diagostics" softkey to obtain a data overview.
The "S1 Spindle Diagnostics" window opens.
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Spindle function
8.4 Spindle diagnostics
Value
h
°C
V
Yes/No
rpm
209