Cutting Parameter Identifiers - Siemens SINUMERIK 828D Commissioning Manual

Tool management
9.2 Configuring the user interface
Identifier
ToolMaxAcc
ToolInMultiTool
ToolInMultiToolPlace
ToolMyMultiTool
ToolMyMultiToolPlace
ToolAlarmIsExtended
ToolAlarmLimit
ToolExtAlarmLimit
ToolUser_1, ... ToolUser_10
ToolAppl_1, ... ToolAppl_10
Parameter corresponds to the system variable or the system variable is the basis for this parameter.
*)
Note
Tool name "ToolIdent"
The maximum length of tool names is 31 ASCII characters.
The number of characters is reduced for Asian characters or Unicode characters.
The following special characters are not permitted: | # "
9.2.2.2

Cutting parameter identifiers

For the cutting parameters, the following identifiers are used in the configuration file:
Identifier
EdgeNo
EdgeNoIdx
ToolType
CuttEdgePos
GeoLength1
GeoLengthGeoAx1
GeoLength
GeoLength2
GeoLengthGeoAx3
GeoLength3
GeoLengthGeoAx2
GeoRadius
GeoCornerRadius
242
Parameter or property
Maximum acceleration
Multitool in which the tool is located
Multitool location containing the tool
Owner multitool of the tool
Owner multitool location of the tool
PLC tool status - function "extended alarm" ac‐
tive
PLC tool status - alarm limit reached
PLC tool status - limit "extended alarm" reached -
OEM tool parameters 1 to 10
Siemens application tool parameters 1 to 10
Parameter or property
D number
Cutting edge number
Tool type, cutting parameter 1
Cutting edge position, cutting parameter 2
Length 1, cutting parameter 3
Length of geometry axis 1, cutting parameter 3, e.g.
length X
Length, cutting parameter 3
Length 2, cutting parameter 4
Length of geometry axis 3, cutting parameter 4, e.g.
length Z
Length 3, cutting parameter 5
Length of geometry axis 2, cutting parameter 5, e.g.
length Y
Radius, cutting parameter 6
Corner radius, cutting parameter 7
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
System variable
*)
$TC_TP_MAX_
ACC
$A_TOOLMTN
$A_TOOLMTLN
$A_MYMTN
$A_MYMTLN
-
-
$TC_TPC1, ...
$TC_TPC10
$TC_TPCS1, ...
$TC_TPCS10
System variable
*)
-
-
$TC_DP1
$TC_DP2
$TC_DP3
$TC_DP3
$TC_DP3
$TC_DP4
$TC_DP4
$TC_DP5
$TC_DP5
$TC_DP6
$TC_DP7
SINUMERIK Operate