Siemens SINUMERIK 828D Commissioning Manual page 515

$TC_CARR37[n]
Decimal place
TEN THOUSANDS
HUNDRED THOU‐
SAND
ONE MILLION / TEN
MILLION
HUNDRED MILLION
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
Display variants of the input screens for CYCLE800
Meaning
3 = Direction reference, rotary axis 1, direction selec‐
4 = Direction reference, rotary axis 2, direction selec‐
5 = No direction reference display for kinematics
8 = Direction reference, rotary axis 1, direction selec‐
9 = Direction reference, rotary axis 2, direction selec‐
Selection field correction of the tool tip
0 = No display of the correction of the tool tip input field.
1 = Correction of tool tip by means of TRAORI.
2 = No correction of the tool tip.
3 = Correction of the tool tip: This function assumes
reserved
Selection field, retraction
00 = No retraction
01 = Retraction Z
02 = Retraction Z, XY
03 = Retraction Z or Z, XY
04 = Maximum retraction in tool direction
...
08 = Incremental retraction in tool direction
...
15 = Retraction Z or Z, XY or
Swivel data set enabled
Setting swivel data set change
Automatic or manual tool change is only necessary under ShopMill or Shop‐
Turn (→ see also: CUST_800.spf, markers _M2 to _M13).
A swivel data set must be "enabled" in every case (value ≥ 4).
0 = Swivel data set not enabled
4 = Swivel data set enabled
tion Minus in the basic setting of the kinematics.
tion Minus in the basic setting of the kinematics.
which only have one solution. Direction selection
(_DIR) Plus is generated in the cycle call CY‐
CLE800.
tion Plus in the basic setting of the kinematics.
tion Plus in the basic setting of the kinematics.
The values 1, 2, 6 and 7 are not permitted.
option "5-axis transformation (TRAORI)".
in maximum tool direction or in incremental tool
direction
$TC_CARR38[n]
$TC_CARR39[n]
$TC_CARR40[n]
Automatic swivel data set and tool change
Configuring cycles
7.7 Swiveling
Retraction position X
Retraction position Y
Retraction position Z
147