Siemens SINUMERIK 828D Commissioning Manual page 688

Tool management
9.8 Editor for the tool and magazine management
Element values
You are currently located under the "Active data" → <tool unit> directory in the "Commissioning"
→ "NC" →"Tool management" operating area.
You can link the following parameters with each other from the selection list via the
Assignments element:
● Spindle/gripper/loader for magazine
● Gripper/loader for spindle
● Loading point for magazine
Note
The separation as number of locations from the magazine zero point of the affected magazine
to the internal magazine location must be defined for each magazine assignment.
Example
If, for example, tools on a spindle must be replaced from a magazine, the following assignment
can result:
Parameters
Spindle/gripper/loader for
magazine
Gripper/loader for spindle
Loading point for magazine
320
Assignment
● Tool spindle location 1 for magazine (separation 0)
● Gripper location 2 for magazine (separation 0)
● Gripper location 3 for magazine (separation 0)
● Transfer location 4 for magazine (separation 0)
● Tool spindle location 1 for gripper 2
● Tool spindle location 1 for gripper 3
● Loading point location 1 for magazine (separation 0)
● Loading point location 2 for magazine (separation 3)
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate