Siemens SINUMERIK 828D Commissioning Manual page 497

Example
You must configure the following machine data, for example, for a turning machine with X1,
Z1 and Y1 axis as well as a main spindle (C1) and a tool spindle (SP1):
MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB[ ]
[0] = 1
[1] = 0
[2] = 2
MD20110 $MC_RESET_MODE_MASK
Bit 0 = 1
Bit 7 = 0
MD20112 $MC_START_MODE_MASK
Bit 7 = 1
MD20118 $MC_GEOAX_CHANGE_RESET
= 1
MD20140 $MC_TRAFO_RESET_VALUE
= 5
MD20144 $MC_TRAFO_MODE_MASK
Bit 0 = 1
MD20070 $MC_AXCONF_MACHAX_USED[4]
= 5
MD20080 $MC_AXCONF_CHANAX_NAME_TAB[ ]
[0] = X1
[1] = Z1
[2] = C1
[3] = SP1
[4] = Y1
Data set for inclined axis:
MD24430 $MC_TRAFO_TYPE_5
= 1024
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
1st real geometry axis X1 axis.
2nd real geometry axis Y1 axis does not exist.
3rd real geometry axis Z1 axis.
TRAANG is retained after ramp-up.
TRAANG is retained after "Cycle start".
Allow automatic geometry axis change.
TRAANG always active after reset.
TRAANG runs in the background (persistent) and is not shown on the user interface.
Channel axis Y1 = 5th machine axis.
1st channel axis X1
2nd channel axis Z1
3rd channel axis C1
4th channel axis SP1
5th channel axis Y1
Transformation 5: TRAANG
Configuring cycles
Assignment of geometry axis to channel
axis.
Name of channel axis in the channel.
7.5 Turning
129