Siemens SINUMERIK 828D Commissioning Manual page 420

Customizing the "Machine" operating area
5.4 Configuring the channel operational message
File
The settings for this are specified in the "slmahdconfig.ini" file.
Configuring the channel operational message
Section
CondStopIcons
CondDelayTime
Procedure
1. Copy the "slmahdconfig.ini" file from the /siemens/sinumerik/hmi/template/cfg directory.
2. Place the file in the following directory: /oem/sinumerik/hmi/cfg or /user/sinumerik/hmi/cfg.
3. Open the file and make the required settings.
"slmahdconfig.ini" file
Standard configuration
[CondStopIcons]
Default icon = condwait.png
1 =
2 =
3 =
4 =
5 =
6 =
7 =
8 =
9 =
10 = condwait.png
11 = condwait.png
12 = condstop.png
13 = condwait.png
52
Meaning
Specification of an icon that is to be displayed with a certain channel operational
message.
If no icon is specified for a certain channel operational message, then the icon
specified for "DefaultIcon" is displayed.
Specification of how long (in milliseconds) a certain message must be present
before it is displayed.
● If no time is specified for a certain channel operational message, then the time
specified at "CondDelayTime" is used.
● If the channel operational message is to be displayed immediately, "0" must
be specified as time.
condstop.png ; No NC ready
condstop.png ; No mode group ready
condstop.png ; EMERGENCY STOP active
condstop.png ; Alarm with stop active
condstop.png ; M0/M1 active
condstop.png ; Block in SBL mode terminated
condstop.png ; NC stop active
condstop.png ; Read-in enable missing
condstop.png ; Feed enable missing
; Dwell time active
; Aux. function acknowledgment missing
; Axis enable missing
; Exact stop not reached
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
SINUMERIK Operate