Siemens SINUMERIK 828D Commissioning Manual page 595

Supplementary conditions:
● MD52200 $MCS_TECHNOLOGY = 2 (milling)
● MD52201 $MCS_TECHNOLOGY_EXTENSION = 0
Default settings for unloading/loading and relocating
MD52272 $MCS_TM_TOOL_LOAD_DEFAULT_MAG
= 0
MD52273 $MCS_TM_TOOL_MOVE_DEFAULT_MAG
= 0
MD52274 $MCS_TM_TOOL_LOAD_STATION
= 0
Input limits for wear input
MD51212 $MNS_TM_WRITE_WEAR_ABS_LIMIT
MD51213 $MNS_TM_WRITE_WEAR_DELTA_LIMIT
MD51214 $MNS_TM_WRITE_LIMIT_MASK
Setting the manual tool function
MD22562 $MC_TOOL_CHANGE_ERROR_MODE
Bit 1 = 1
Bit 2 = 1
Note
If, in machine data MD22562 $MC_TOOL_CHANGE_ERROR_MODE bit 2 = 1, then you have
the option, using a correction selection (D No.) in the program, to stop the machine until the
PLC signals that the tool change has been completed. To do this, machine data MD20270
$MC_CUTTING_EDGE_DEFAULT must be set to = 0.
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3
No default magazine, default value
No default magazine, default value
All configured stations are considered, default value
Manual tools can be loaded.
Active D No. > 0 and active T No. = 0 generate an alarm message.
Active D No. > 0 and active D No. = 0 generate an alarm message.
Tool management
9.1 Machine data for tool management
Default magazine for loading tools.
Default magazine for relocating tools.
Number of loading station.
Maximum value of the tool wear.
Maximum differential value of restricted tool
wear input.
Range of validity of the restricted tool wear
input.
Response when errors occur at tool
change.
227