Figure 1-15 Seating The Dcd On The Vpro Graphics Board (Front View) - Silicon Graphics Octane2 Manual

1: Installing the DCD in a Single Head Octane2
18
Note: As you push the board forward, the connectors move into alignment and
partially seat without the assistance of downward pressure.
b. Press down on the top of the DCD I/O panel to fully seat its locator slots over
the VPro graphics board locator tabs (B).
c. Press down gently on the area above the DCD connector to make sure it is fully
seated (C). See Figure 1-16 for a side view seating of the board.
A
B
C
Figure 1-15 Seating the DCD On the VPro Graphics Board (front view)
Figure 1-16 shows a side view seating of the board.
007-4209-003