Figure 1-12 Removing The Vpro Graphics Board Blank Panel - Silicon Graphics Octane2 Manual

007-4209-003
4. Remove the blank panel from the VPro graphics board, as shown in Figure 1-12.
Store the blank panel in a safe place. If you remove the DCD, you need to reinstall
the VPro graphics board blank panel.
Figure 1-12 Removing the VPro Graphics Board Blank Panel
5. Remove the nylon standoff from the bag of parts and install it as follows:
Remove the screw that is located behind the daughterboard connector on the
VPro graphics board (see A in Figure 1-13), and save it for later in the
installation.
Insert the nylon standoff into the hole from which you removed the screw (B).
Seat the nylon standoff by turning it clockwise (C), but do not overtighten.
Connecting the DCD
15