Figure 2-16 Removing The Dual Head Xio Module I/O Panel - Silicon Graphics Octane2 Manual

007-4209-003
9. Using your index finger, lift the upper-right plastic heat-sink stabilizing bracket
away from the heat sink. This is the bracket held in by screws C and D in
Figure 2-15.
10. While holding the bracket up, gently remove the I/O panel from the Dual Head XIO
Module, as shown in Figure 2-16.
Figure 2-16 Removing the Dual Head XIO Module I/O Panel
11. As you remove the I/O panel, be careful not to lose the rubber gaskets located
between the I/O panel and the VPro graphics boards. Save the gaskets for later in
the installation.
Connecting the DCD
51