2: Installing the DCD in a Dual Head Octane2
52
12. Remove the screw holding the DCD blanking panel to the Dual Head XIO Module
I/O panel, as shown in Figure 2-17, and remove the blanking panel.
Removing the DCD Blanking Panel
Figure 2-17
13. Remove the male-to-female nylon standoff from the bag of parts. If the kit includes a
female-to-female nylon standoff, it will not be used in this installation. Install the
standoff as follows:
a.
Remove the screw that is located behind the daughterboard connector on the
VPro graphics board (see A in Figure 2-18), and save it for later in the
installation.
b. Insert the nylon standoff into the hole from which you removed the screw (B in
Figure 2-18).
c.
Seat the nylon standoff by turning it clockwise (C in Figure 2-18), but do not
over-tighten it to avoid stripping the delicate plastic threads.
007-4209-003