Figure 1-14 Positioning The Dcd - Silicon Graphics Octane2 Manual

!
007-4209-003
Caution: The following steps include detailed instructions for aligning the board. You
must follow these specific instructions to avoid damaging the connector pins. If you
attempt to connect the board before properly aligning it, the connector pins will likely be
damaged.
7. Align the DCD I/O panel with the VPro graphics board I/O panel as follows:
Line up the DCD's two outside holes with the two outside holes on the VPro
graphics board (see A in Figure 1-14).
Place the DCD on top of the VPro graphics board.
Line up the two locator slots on the outside of the DCD with the locator tabs on
the outside of the VPro graphics board (B).
A
Align outside holes
Figure 1-14 Positioning the DCD
8. Seat the DCD connector in the VPro graphics board daughterboard slot, as follows:
a. Push the top edge of the DCD I/O panel against the VPro graphics board I/O
panel (see A in Figure 1-15).
B
Place locator slots over locator tabs
Connecting the DCD
17