Figure 2-44 Installing The Dual Head Xio Module I/O Panel - Silicon Graphics Octane2 Manual

007-4209-003
19. Place the two large rubber gaskets over the VPro graphics board connectors, as
shown in Figure 2-44.
20. While lifting the plastic heat-sink stabilizing brackets, gently install the I/O panel
on the Dual Head XIO Module, as shown in Figure 2-44. Make sure that the I/O
panel is installed in the correct orientation.
Figure 2-44 Installing the Dual Head XIO Module I/O Panel
Removing the DCD
83