Figure 2-47 Installing The Center Plastic Knob Retaining Screw - Silicon Graphics Octane2 Manual

2: Installing the DCD in a Dual Head Octane2
86
23. Turn the Dual Head Module over and insert the center plastic knob into the I/O
panel, as shown in Figure 2-47. Make sure that the knob is installed in the correct
orientation. One way of ensuring this is to make sure the spring-loaded screw in the
center plastic knob is aligned over the threaded hole in the I/O panel.
24. Install and tighten the center plastic knob retaining screw, as shown in Figure 2-47.
Retaining screw
location
Figure 2-47 Installing the Center Plastic Knob Retaining Screw
007-4209-003