Figure 2-20 Securing The Dcd To The Nylon Standoff - Silicon Graphics Octane2 Manual

007-4209-003
17. Place the screw you removed from the VPro graphics board into the hole behind the
DCD connector (above the nylon standoff), and then gently tighten the screw by
turning it clockwise, as shown in Figure 2-20. When the screw begins to get tight,
unscrew it about two turns, leaving the DCD slightly loose (you will tighten it the
rest of the way later).
Standoff screw
Securing the DCD to the Nylon Standoff
Figure 2-20
18. If you will install a second DCD at this time, skip to the instructions in "Installing a
Second DCD" on page 64.
Connecting the DCD
55