Removing The Dcd; Figure 2-32 Removing The 13W3 Cover - Silicon Graphics Octane2 Manual

Removing the DCD

007-4209-003
If you want to remove the DCD and connect a monitor to the VPro graphics board
monitor port, follow these steps:
1. Prepare your workstation, as described in "Preparing Your Workstation" on
page 36.
2. Remove the Dual Head XIO Module, as described in "Removing the Dual Head XIO
Module" on page 40.
3. Remove the two screws securing the 13W3 cover to the VPro graphics board, and
then remove the cover, as shown in Figure 2-32.
13W3 cover
13W3 pad
VPro graphics board monitor port
Removing the 13W3 Cover
Figure 2-32
Removing the DCD
71