Connecting The Monitor Power Cables And Powering On Your Workstation; Figure 3-6 Connecting The Power Cables - Silicon Graphics Octane2 Manual

3: Connecting Monitors to the DCD

Connecting the Monitor Power Cables and Powering On Your Workstation

100
Connect the power cable for each monitor as follows (see Figure 3-6):
1. Connect the female end of the power cable to the power connector on the back of
the monitor.
2. Plug the male end into a three-prong grounded electrical outlet.
3. Plug your workstation's power cord into an electrical outlet.
4. Press the power button on the front of your workstation.
5. Press the power switch on the left monitor, then press the power switch on the right
monitor to power on the monitors.
For information on configuring the DCD, proceed to Chapter 4, "Configuring the
DCD".
IN
A C
Connecting the Power Cables
Figure 3-6
IN
A C
007-4209-003