Preparing Your Workstation; Figure 1-2 Powering Off Your Workstation - Silicon Graphics Octane2 Manual

Preparing Your Workstation

007-4209-003
To install the DCD, you must remove your workstation's XIO Tri-Module. Before you
begin this operation, follow these steps:
1. Open the cover and press the power button to power off your workstation (see A in
Figure 1-2).
2. Unplug the power cord (B).
3. Press the monitor power switch to power off your monitor (C).
4. Wait 5 minutes before removing the XIO Tri-Module.
B
Power cable
Powering Off Your Workstation
Figure 1-2
Warning:
The heat sinks on the XIO boards get very hot. Wait 5 minutes after
powering off your workstation before you remove the XIO Tri-Module. Test the
temperature of the heatsinks before handling any of the XIO boards.
Preparing Your Workstation
A
Power button
C
Power switch
5