Figure A-2 Spraying The Compression Connector - Silicon Graphics Octane2 Manual

Appendix A: Care and Cleaning of Compression Connectors
!
120
Spraying the Compression Connector
Figure A-2
3. Hold the can in a vertical position.
4. Place or hold the XIO board so that the rounded edge of the compression connector
faces up. Note that the rounded edge is completely closed, so that air cannot flow
into the connector, whereas the squared edge has an opening (see Figure A-2.)
Caution: Spraying into the squared (open) edge of the connector can destroy it.
007-4209-003