Connecting The Monitor Cables To The Monitors - Silicon Graphics Octane2 Manual

3: Connecting Monitors to the DCD

Connecting the Monitor Cables to the Monitors

90
Connect the monitor cables as follows:
1. Power off your workstation.
2. Place the monitors side by side.
3. Connect the VGA end of each DVI/VGA cable to the VGA connector on the back of
each monitor, and then tighten the thumbscrews on both sides of each connector
(see Figure 3-1).
4. Face the front of the monitors and place one monitor on the left and the other
monitor on the right.
007-4209-003