Figure 2-21 Installing The Dual Head Xio Module I/O Panel - Silicon Graphics Octane2 Manual

2: Installing the DCD in a Dual Head Octane2
56
19. Place the two rubber gaskets over the VPro graphics board connectors, as shown in
Figure 2-21.
20. Place the two new rubber gaskets over the two DCD connectors, as shown in
Figure 2-21.
21. Using your index finger, lift the upper-right plastic heat-sink stabilizing bracket.
This is the bracket held in by screws C and D in Figure 2-15.
22. While holding the bracket up, gently install the I/O panel on the Dual Head XIO
Module, as shown in Figure 2-21. Make sure that the I/O panel is installed in the
correct orientation.
Figure 2-21 Installing the Dual Head XIO Module I/O Panel
007-4209-003