Figure 1-27 Connecting A Monitor To The Vpro Graphics Board - Silicon Graphics Octane2 Manual

1: Installing the DCD in a Single Head Octane2
32
6. Reinstall the XIO Tri-Module, as described earlier in this chapter.
7. Connect a monitor to the VPro graphics board monitor port, as shown in
Figure 1-27.
8. Connect one end of the monitor power cable to your workstation and the other end
to a 3-prong grounded electrical outlet.
9. Reconnect your workstation's power cable.
10. Power on your workstation and monitor.
To monitor
Figure 1-27 Connecting a Monitor to the VPro graphics board
007-4209-003