Figure 4-2 Load Confirmation Dialog Box - Silicon Graphics Octane2 Manual

007-4209-003
3. To enable dual channel mode, select a DCD setting from the Valid Formats field. To
disable dual channel mode, select a single channel display setting from the Valid
Formats field.
Note: DCD settings have a "2@" prefix. Single channel display settings do not have
a "2@" prefix.
4. Click the Load button next to the Valid Formats title bar.
If your display setting has the character D in the first column, a confirmation dialog
box will appear, as shown in the example in Figure 4-2.
Note: If you select a display setting that does not show the character D in the first
column, you must log out, and then log in again to activate the settings, as explained
later in step 6.
Load Confirmation Dialog Box
Figure 4-2
5. Click the OK button to confirm your display setting.
Another dialog box will appear that asks if you want to use this display setting as
the power-on default, as shown in the example in Figure 4-3.
Enabling and Disabling the DCD Setting
105