Figure 1-20 Placing The 13W3 Cover Over The Vpro Graphics Board Monitor; Port - Silicon Graphics Octane2 Manual

007-4209-003
11. Remove the 13W3 cover and the two screws from the bag of parts.
12. Place the 13W3 cover over the VPro graphics board monitor port, with the padded
side of the cover facing the monitor port, as shown in Figure 1-20.
When a monitor is not connected to the VPro graphics board monitor port, you
must install the 13W3 cover to ensure that the system complies with local and
international EMC regulations.
13. Align the two outside holes of the 13W3 cover with the two thumbscrew holes on
the sides of the VPro graphics board monitor port.
13W3 cover
13W3 pad
Figure 1-20 Placing the 13W3 Cover over the VPro Graphics Board Monitor Port
VPro Graphics Board monitor port
Connecting the DCD
23