Returning Parts - Silicon Graphics Octane2 Manual

If Neither Monitor Has an Image (Silicon Graphics Octane2)
If Neither Monitor Has an Image (Silicon Graphics Fuel Workstation)

Returning Parts

007-4209-003
1. Remove the cover from the 13W3 monitor port on the VPro graphics board.
2. Connect a monitor to the 13W3 monitor port.
3. Open a UNIX shell.
4. At the prompt, enter
A hardware inventory list should appear, similar to the one shown in Figure 3-7.
5. Look for the following line that describes the DCD:
Dual Channel Display
If the above line does not appear, return to Table 5-1.
1. Connect a monitor to the original single DVI port on the graphics board.
2. Open a UNIX shell.
3. At the prompt, enter
A hardware inventory list will appear, similar to the one shown in Figure 3-7.
4. Look for the following line describing the DCD:
Dual Channel Display
If the above line does not appear, see Table 5-1 for additional information.
To return any part, use the packaging materials and box included with your part.
hinv:
hinv:
Returning Parts
115