Removing The Dcd - Silicon Graphics Octane2 Manual

1: Installing the DCD in a Single Head Octane2

Removing the DCD

28
If you want to remove the DCD and connect a monitor to the VPro graphics board
monitor port, follow these steps:
1. Power off and prepare your workstation, as described earlier in this chapter.
2. Remove the XIO Tri-Module, as described earlier in this chapter.
3. Remove the DCD as follows (see Figure 1-24):
a. Remove the three screws that secure the DCD I/O panel to the VPro graphics
board I/0 panel.
b. Remove the standoff screw.
c. Remove the DCD and store it in an antistatic bag.
Note: As you remove the DCD, make sure its locator slots are completely detached
from the VPro graphics board locator tabs.
007-4209-003