Figure 4-6 Accumulation Buffer Confirmation Dialog Box - Silicon Graphics Octane2 Manual

4: Configuring the DCD
108
Figure 4-6 Accumulation Buffer Confirmation Dialog Box
5. Click the OK button to use this accumulation buffer type as the power-on default, or
click the Cancel button to retain the current default.
If you click the OK button, a dialog box appears that says you must log out for the
new settings to take effect, as shown earlier in Figure 4-5.
6. Click the OK button in the dialog box.
7. Exit xsetmon and close all active applications.
8. Log out and then log in again to activate your new settings.
007-4209-003