Figure 2-29 Inserting The Dual Head Module With Dcd - Silicon Graphics Octane2 Manual

2: Installing the DCD in a Dual Head Octane2
68
1. Remove the cap from the Dual Head XIO Module compression connectors.
2. Slide the Dual Head XIO Module into the guides on the top and bottom of the
workstation, as shown in Figure 2-29. Be sure the module is oriented correctly, as
shown in Figure 2-28.
Before you insert the Dual Head XIO Module, make sure the center plastic knob
protrudes from the I/O panel, as shown in Figure 2-29.
If the center plastic knob is flush with the I/O panel, the Dual Head XIO Module
will stop before it is fully inserted. If this happens, pull the entire assembly out of
the slot about an inch (2.5 cm), pull out the center knob, and then continue inserting
the Dual Head XIO Module into the chassis.
Inserting the Dual Head Module with DCD
Figure 2-29
007-4209-003