Figure 2-7 Removing The Dual Head Xio Module - Silicon Graphics Octane2 Manual

2: Installing the DCD in a Dual Head Octane2
42
3. Grasp the handles on the Dual Head XIO Module and slide the module out of the
chassis, as shown in Figure 2-7. You may also want to support the bottom of the
module while sliding it out.
The center plastic knob protrudes when the Dual Head XIO Module is out of the
chassis.
Note: Do not push on the knob after you have removed the Dual Head XIO Module
from the chassis. The module locks to the workstation only if the knob is protruding.
4. Place the Dual Head XIO Module on a flat, antistatic surface. An empty antistatic
bag on your desk works well.
G e n
lo ck
S w a
p
R e a L
d y
R
L A T
C H
U N L
A T C
R H
L
S w a
p
R e a
d y
G e n
lo ck
Removing the Dual Head XIO Module
Figure 2-7
007-4209-003