Connecting The Dcd; Figure 1-9 Placing The Xio Tri-Module On Its Side - Silicon Graphics Octane2 Manual

1: Installing the DCD in a Single Head Octane2

Connecting the DCD

!
12
The DCD connects to the daughterboard slot on the XIO Tri-Module VPro graphics
board.
Caution: The following steps include detailed instructions for aligning the board. You
must follow these specific instructions to avoid damaging the connector pins. If you
attempt to connect the board before properly aligning it, the connector pins will likely be
damaged.
1. Place the XIO Tri-Module on a flat, antistatic surface with the VPro graphics board
I/O panel on the left side, as shown in Figure 1-9. An empty antistatic bag on your
desk works well.
When the XIO Tri-Module is out of the chassis, the sliding handles must protrude.
A label identifies each XIO slot (B on one side, C on the other). Slot B is the
daughterboard slot where you connect the DCD, as described later in this chapter.
VPro Graphics Board
I/O panel
Figure 1-9 Placing the XIO Tri-Module on Its Side
Daughterboard slot
Place cap
on compression connector
007-4209-003