Checking Your Graphics Board - Silicon Graphics Octane2 Manual

Checking Your Graphics Board

007-4209-003
To use the DCD, your workstation must have a VPro V12 graphics board installed. If you
have a Dual Head workstation, see Chapter 2, "Installing the DCD in a Dual Head
Octane2".
To verify that your system contains a VPro V12 graphics board, follow these steps:
1. Open a UNIX shell.
2. At the prompt, enter
You will see output similar to the following:
2 250 MHZ IP30 Processors
CPU: MIPS R10000 Processor Chip Revision: 3.4
FPU: MIPS R10010 Floating Point Chip Revision: 0.0
Main memory size: 512 Mbytes
Xbow ASIC: Revision 1.4
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 1 Mbyte
Integral SCSI controller 0: Version QL1040B (rev. 2), single ended
Disk drive: unit 1 on SCSI controller 0
Integral SCSI controller 1: Version QL1040B (rev. 2), single ended
IOC3 serial port: tty1
IOC3 serial port: tty2
IOC3 parallel port: plp-1
Graphics board: V12
Integral Fast Ethernet: ef0, version 1, pci 2
Iris Audio Processor: version RAD revision 12.0, number 1
3. Look for the following line describing your graphics board:
Graphics board: V12
If your graphics board is not listed as V12, you cannot use the DCD. For more
information, contact your authorized SGI sales representative.
hinv
Checking Your Graphics Board
3