Table 7-4 Error Messages Of The Logsave Command - Hitachi HF-BX1000 Instruction Manual

<Diagnosis>
When this command is terminated with an error, the following error message is displayed.
If a directory for saving data does not exist, an error message from the Windows® xcopy
command is displayed.
Error: You do not have the privilege to run this command.
Please run this command again on "Administrator: Command
Prompt".
< NOTE >
• When you run the logsave command, log on to the computer by using an
administrator account registered on computer (as a member of the
Administrators group). You cannot run multiple instances of the logsave
command simultaneously.
• If User Account Control (UAC) is enabled, start the command prompt with
administrator privileges according to "7.5 (1) Starting a command prompt" and
run the command.
• The log information can also be collected by using a program in the start menu.
For details, refer to "HF-BX1000/1200 RAS FEATURES MANUAL".
• The size of the file after compression depends on how the equipment is used
and how Windows® is set up, but roughly speaking, the size is about 10 MB.

Table 7-4 Error Messages of the logsave Command

Error message
You do not have administrator privileges.
Log on to the computer by using an
administrator account and run the
command again. If User Account Control
(UAC) is enabled, start the command
prompt with administrator privileges and
run the command.
7-15
7. MAINTENANCE OPERATION
Meaning