1. GETTING STARTED
1.2 Installation Environment
If you keep at high temperature this equipment, do not touch bare hands.
Otherwise you may result burns.
When this equipment is used, it must be used in the following environment. (*1)
Power supply noise
Electrostatic noise contact
Transient power fault
(*1) Environmental conditions that must be satisfied are the same for HF-BX1000 and
(*2) This equipment cannot be used in the environment where conductive dust or the
like is floating.
(*3) If a square wave uninterruptible power supply (UPS) is connected to the
equipment, the equipment may fail. Do not use this type of UPS.
(*4) Be cautious when you use the equipment in the environment subject to noise such
as electrostatic noise. Depending on the severity of the noise, failures such as a
disruption on the LAN may occur. When a user builds a system, make sure that
the system can recover (retry) automatically.
< NOTE >
• For information about the precautions for the environment, see
"PRECAUTIONS 1. PRECAUTIONS ABOUT THE EQUIPMENT
(5) INSTALLATION ENVIRONMENT".
Operation: 5 to 40°C
Storage: -10 to 60°C
±10 K/h or less
20 to 80%RH (non-condensing)
± 10% RH/h or less
No heavy dust
JEITA IT-1004A class A (Temperature 25℃,
Humidity 50% RH)
Operation: 19.6 m/s
100 to 240 VAC (*3)
50/60 Hz ± 3 Hz
2.0 kV (fast transient / burst wave)
4 kV (Air: 8 kV) (*4)
500 VDC, 5 MΩ
1.5 kVAC, one minute
10 ms or less
1000 m or less.
or less (JEITA IT-1004A class B))
(10 Hz, 5 s)
(while not powered on: 98 m/s