Installation Environment; Environment; Installation - Hitachi HF-BX1000 Instruction Manual

1.2.2 Installation

The power cord that comes with the equipment is rated at the input voltage of
125 VAC. When using this equipment at over 125 VAC, prepare the power
cord fitting input voltage and inspect the safeness of this equipment enough.
 When you connect the plug of the power cord to an outlet, make sure you use
an outlet with a ground terminal (ground pole) that is properly grounded. In
addition, you must install and use an earth leakage circuit breaker.
If you do not take these measures, that may result in a fire or an electric shock.
 Do not use a two-pole plug without a ground pole because that may result in an
electric shock or failure of the equipment.
 Before you move this equipment, make sure you shut down the OS, disconnect
the plug of the power cord from the outlet, and wait for at least one minute. If
you do not, the HDDs and other devices may fail.
 When you transport or carry the equipment, pack it in the dedicated container
(container and packing materials used when the equipment was delivered). If
you use other container or packing materials, that may damage the equipment.
 Do not use damaged or broken dedicated container when you transport or
carry the equipment. If you do, that may damage the equipment.
 If you install the equipment in a mounting chassis or rack with casters, the
equipment may be subjected to excessive vibration or shock when it is
transported or moved and that may cause the equipment to fail. In order to
avoid failure, you must select or design a chassis or rack that satisfies the
installation environment requirements of the equipment and be cautious about
vibration and shock when you move, transport, or carry the installed
equipment.
< NOTE >
• For information about the precautions for concerning installation requirements,
see "PRECAUTIONS 1. PRECAUTIONS ABOUT THE EQUIPMENT

(5) INSTALLATION ENVIRONMENT".

WARNING
NOTICE
1-3
1. GETTING STARTED