Table 7-9 Error Messages Of The Getrasinfo Command - Hitachi HF-BX1000 Instruction Manual

Industrial computer

Table of Contents

7. MAINTENANCE OPERATION

When this command finishes normally, the getrasinfo command returns exit code 0. When this

command is terminated with an error, one of the following error messages is displayed and exit

code 1 is returned.

Usage: getrasinfo [/status | /setting] [/e File]

An error occurred in %s. errorcode=%x.

%s: Name of the Windows API function or internal function

where the error occurred

%x: Error code from the Windows API or internal function

You do not have the privilege to run this command.

Please run this command again on "Administrator: Command

Prompt".

< NOTE >

• When you run the getrasinfo command, log on to the computer by using an

administrator account registered on the computer (as a member of the

Administrators group). You cannot run multiple instances of the getrasinfo

command simultaneously.

• If User Account Control (UAC) is enabled, start the command prompt with

administrator privileges according to "7.5 (1) Starting a command prompt" and

run the command.

• When the /e option is used, if a file with the same name as the output file

already exists at the same output location, the file is overwritten.

• If the command fails to acquire some of the information required for the output,

it is possible that only the section name is displayed in a section or a part of the

information is replaced with "---". If this situation happens, re-execute the

command.