Hitachi HF-BX1000 Instruction Manual page 13

SAFETY INSTRUCTIONS (Continued)
 Before you move this equipment, make sure you shut down the OS,
disconnect the plug of the power cord from the outlet, and wait for at least
one minute. If you do not, the HDDs and other devices may fail.
 When you transport or carry the equipment, pack it in the dedicated container
(container and packing materials used when the equipment was delivered). If
you use other container or packing materials, that may damage the
equipment.
 Do not use damaged or broken dedicated container when you transport or
carry the equipment. If you do, that may damage the equipment.
 If you install the equipment in a mounting chassis or rack with casters, the
equipment may be subjected to excessive vibration or shock when it is
transported or moved and that may cause the equipment to fail. In order to
avoid failure, you must select or design a chassis or rack that satisfies the
installation environment requirements of the equipment and be cautious
about vibration and shock when you move, transport, or carry the installed
equipment.
 Do not route interface cables and the like near the power cord. If you do,
failure and malfunction of the equipment may result.
 Do not connect or disconnect an interface cable while the power for this
equipment or for the remote device is on. If you do, failure of the equipment
may result due to a short circuit between the power supply and the ground.
When an interface cable comes off while the power for the equipment is on,
shut down the OS and disconnect the power cord from the outlet.
Disconnecting the power cord from the outlet without shutting down the OS
might destroy the internal files.
 Never hot-swap HDDs because that may cause failure of the equipment and
HDDs. Before you replace an HDD, make sure you shut down the OS,
disconnect the plug of the power cord from the outlet, and wait for at least
one minute.
 When using a USB port, check the orientation of the USB connector, and
then insert the connector slowly. Otherwise, the USB port may be damaged.
 Do not remove or insert a USB device during online operation (system
operation) because that may affect currently running applications.
 PS/2 port is not supported. Make sure you inspect enough when you use this
port. The power of the PS/2 port is active continuously during the standby in
this equipment. Before you install or remove PS/2 devices, make sure you
shut down the OS, disconnect the plug of the power cord from the outlet, and
wait for at least one minute.
(See page 1-3.) (See page 5-1.)
S-10
(See page 1-8.)
(See page 2-1.)