Setting Up The Lan Interface - Hitachi HF-BX1000 Instruction Manual

3.7 Setting Up the LAN Interface

This equipment has two built-in 1000BASE-T/100BASE-TX/10BASE-T LAN port. For
information about the location of the LAN port connector (1000BASE-T/100BASE-TX/
10BASE-T), see "2.1 Display and User Input Sections".
< NOTE >
• For information about the precautions for the network, see "PRECAUTIONS
2. NETWORK".
 Automatic recognition of the network transfer speed or transfer mode
The LAN port has an auto-negotiation function to automatically recognize the network
transfer speed or transfer mode. For normal use, enable the auto-negotiation function.
(Especially when you use the WOL function. If the speed is fixed to 1000Mbps (auto-
negotiation), the WOL function cannot be used.)
If there is a compatibility issue with the connected hub, the auto-negotiation function may
not work properly and that may affect the communication with other terminals.
If the auto-negotiation function does not work properly, configure the LAN interface as
follows.
Specification of the hub
10 Mbps / Half-duplex
10 Mbps / Full-duplex
100 Mbps / Half-duplex
100 Mbps / Full-duplex
1000 Mbps
(*) How the setting is displayed is different depending on the OS and the LAN
port in use.
Specification of the LAN setting (*)
Speed
10 Mbps
10 Mbps
100 Mbps
100 Mbps
1000 Mbps (1.0 Gbps)
3-7
3. OPERATION
Speed
Half Duplex
Full Duplex
Half Duplex
Full Duplex
Auto Negotiation or
Full Duplex