Download  Print this page

Figure 4-2 Outward Of Gpio Cable And Connector - Hitachi HF-BX1000 Instruction Manual

Industrial computer
Hide thumbs

Advertisement

(3) Recommended specification of GPIO cable
Do not connect the No. 1 pin and No. 2 pin of GPIO contact. When these are
connected to the connector on the user's equipment, this equipment may not
operate normally.
Make sure to confirm connector specification before creating a cable by a user.
If a user connect a cable which was mistaken about connector specification to
this equipment, this equipment may not operate normally.
Prepare the GPIO cable that conforms to the recommended specifications shown below by a user.
Connector for GPIO
6
1
9
5
(*1) The maximum cable length is 1.5 m. The cable length should use less than 1.5 m.
(*2) Contact the shield ground of a cable to the conductor of a plug case(frame ground)certainly.
In addition, since all the GND pins of GPIO are the signal grounds, do not connect a shield
ground. If you do, it may occur the malfunction.
Connector specification of EXT side (recommendation)
Part's name
Plug case
Male connector
Cable specification (recommendation)
Maximum cable length
Electrical cable shield
Recommended cable
Pulg case

Figure 4-2 Outward of GPIO cable and connector

Connetor form:D-sub 9 pin Male connector
DE-C8-J9-F1-1R
Item
UL2464SB 5P×24AWG
NOTICE
Model
DEU-9PF-F0
Specification
1.5m
Necessity
4-19
4. SPECIFICATIONS
Cable (*1)(*2)
User equipment side
connector form:
unite with a user's
equipment.
Maker
JAE
JAE
Remark
Connect to frame ground
Hitachi Metals

Advertisement

loading

  Related Manuals for Hitachi HF-BX1000

This manual is also suitable for:

Hf-bx1200