Figure 2-3 Hf-Bx1000 Name Of Each Part (Front View) - Hitachi HF-BX1000 Instruction Manual

LAN port
(2 ports)
Communication
speed lamp
ACT/LINK lamp
LAN ports:
1000BASE-T/100BASE-TX/
10BASE-T
HDD2 status lamp
HDD1 status lamp
Power lamp
Power switch
Reset switch (*2)
AC inlet
PS/2port (*3)
Upper：Mouse
Lower：Keyboard

Figure 2-3 HF-BX1000 Name of Each Part (Front View)

(*1) In the case of A model, there is no HDD2 status lamp.
In the case of D model, HDD status lamp will blinks either one or both, when reading or writing HDDs.
(*2) Press the reset switch by inserting an eject pin. If an eject pin is not available, use a pin that fits the hole of the reset
switch instead.
(*3) PS/2 port is not supported. Make sure you inspect enough when you use this port.
LAN port
Left: LAN A
Right: LAN B
(*1)
(*1)
Digital LED for
Status indication
Serial port
(2 ports)
Displayport
HDMI port
USB port
(2 ports)
RM.SW/GPIO port
USB port
(4 ports)
Analog RGB port
2-3
2. PHYSICAL CONFIGURATION
Drive bay 1 (HDD1)
Drive bay 2 (HDD2)
Audio port
Upper: LINE IN
Center: LINE OUT
Lower: MIC