Lan Commands; Lan:apply; Lan:autoip - Rigol DS4000E Series Programming Manual

RIGOL

:LAN Commands

Command List:

:LAN:APPLy



:LAN:AUToip


:LAN:DHCP

:LAN:DNS

:LAN:GATeway

:LAN:INITiate

:LAN:IPADdress

:LAN:MAC?

:LAN:MANual

:LAN:SMASk

:LAN:STATus?

:LAN:VISA?

:LAN:APPLy
Syntax
:LAN:APPLy
Description
Applies the current network parameter configuration.
Remarks
After the configuration for the network parameters is finished, the new configuration for network
parameters will only take effect when you apply the current network parameter configuration.
:LAN:AUToip
Syntax
:LAN:AUToip <bool>
:LAN:AUToip?
Description
Turns on or off the auto IP configuration mode; or queries the on/off status of the auto IP configuration
mode.
Parameter
Name Type
<bool> Bool
Remarks
The high-to-low priority of the three IP configuration modes is "DHCP", "Auto IP" and "Static IP". The

three IP configuration modes cannot be all turned off at the same time. To use the auto IP
configuration mode, turn on this configuration mode and turn off the DHCP configuration mode.
When the auto IP configuration mode is valid, the oscilloscope will get the IP addresses from

169.254.0.1 to 169.254.255.254 and the subnet mask 255.255.0.0 automatically according to the
current network configuration; besides, you can define the gateway address (refer to
the :LAN:GATeway command) and the DNS server address (refer to the :LAN:DNS command).
Return Format
The query returns 1 or 0.
2-104
Range
{{1|ON}|{0|OFF}}
Chapter 2 Command System
Default
1|ON
DS4000E Programming Guide