RIGOL
Command List:
:WAVeform:BEGin
:WAVeform:DATA?
:WAVeform:END
:WAVeform:FORMat
:WAVeform:MODE
:WAVeform:POINts
:WAVeform:PREamble?
:WAVeform:RESet
:WAVeform:SOURce
:WAVeform:STARt
:WAVeform:STATus?
:WAVeform:STOP
:WAVeform:XINCrement?
:WAVeform:XORigin?
:WAVeform:XREFerence?
:WAVeform:YINCrement?
:WAVeform:YORigin?
:WAVeform:YREFerence?
:WAVeform:BEGin
Syntax
:WAVeform:BEGin
Description
Starts the waveform data reading.
Remarks
This command is only applicable to reading waveform data in the internal memory (refer to
the :WAVeform:MODE command).
:WAVeform:DATA?
Syntax
:WAVeform:DATA?
Description
Queries the waveform data in the buffer.
Remarks
You can use the :WAVeform:FORMat, :WAVeform:MODE, :WAVeform:POINts, and :WAVeform:SOURce
commands to set various parameters for the waveform data reading.
Note: Turn on the display of the source channel (refer to the :WAVeform:SOURce command) before
querying the waveform data.
Procedures of reading the waveform data on the screen:
S1. :WAV:SOUR CHAN1
S2. :WAV:MODE NORM
S3. :WAV:DATA?
2-240
Sets the source channel of waveform data reading to CH1
Sets the waveform data reading mode to NORMal
Obtains data from the buffer
Chapter 2 Command System
DS4000E Programming Guide