Bus<N>:Flexray (Option) - Rigol DS4000E Series Programming Manual

RIGOL
:BUS<n>:FLEXray (Option)
Command List:
:BUS<n>:FLEXray:BAUD

:BUS<n>:FLEXray:OFFSet

:BUS<n>:FLEXray:SOURce

:BUS<n>:FLEXray:SPoint

:BUS<n>:FLEXray:STYPe

:BUS<n>:FLEXray:THReshold

:BUS<n>:FLEXray:BAUD
Syntax
:BUS<n>:FLEXray:BAUD <baud>
:BUS<n>:FLEXray:BAUD?
Description
Sets or queries the signal rate of FlexRay decoding on the specified bus. The default unit is b/s.
Parameter
Name Type
<n> Discrete
<baud> Discrete
Return Format
The query returns 2500000, 5000000, or 10000000.
:BUS<n>:FLEXray:OFFSet
Syntax
:BUS<n>:FLEXray:OFFSet <val>
:BUS<n>:FLEXray:OFFSet?
Description
Sets or queries the vertical position of FlexRay decoding on the specified bus.
Parameter
Name Type
<n> Discrete
<val> Integer
Remarks
Before using the command, enable the display of the specified decoding bus (refer to

the :BUS<n>:DISPlay command).
The range of <val> is related to the screen display mode and the on/off status of the statistic function

(refer to the :MEASure:STATistic:DISPlay command).
When the display mode is "Full Screen" and the statistics function is disabled, the <val> parameter
ranges from -166 to +148.
When the display mode is "Full Screen" and the statistics function is enabled, the <val> parameter
ranges from -163 to +143.
When the display mode is "Split" (refer to the :TIMebase:DELay:ENABle and :CALCulate:FFT:SPLit
command), the <val> parameter ranges from -103 to +52.
When the data line that displays the decoding is located in the middle part of the screen, <val> is 0;

when it is located above the middle part of the screen, <val> is a positive value; when it is located
2-14
Range
{1|2}
{2500000|5000000|10000000}
Range
{1|2}
Refer to Remarks
Chapter 2 Command System
Default
--
10000000
Default
--
0
DS4000E Programming Guide