Mask:operate; Mask:output - Rigol DS4000E Series Programming Manual

Chapter 2 Command System
Parameter
Name Type
<bool> Bool
Remarks
The display of the statistic information of the pass/fail test results can only be turned on when the pass/fail
test function is enabled (refer to the :MASK:ENABle command).
Return Format
The query returns 1 or 0.

:MASK:OPERate

Syntax
:MASK:OPERate <oper>
:MASK:OPERate?
Description
Runs or stops the pass/fail test operation.
Parameter
Name Type
<oper> Discrete
Remarks
You can only run the pass/fail test operation when the pass/fail test function is enabled (refer to
the :MASK:ENABle command).
Return Format
The query returns RUN or STOP.

:MASK:OUTPut

Syntax
:MASK:OUTPut <type>
:MASK:OUTPut?
Description
Enables or disables the alarm function; or queries the on/off status of the alarm function.
Parameter
Name Type
<type> Discrete
Remarks
FAIL: When a failed waveform is detected, the oscilloscope displays the statistic results and outputs a

pulse; but the beeper does not sound.
FSOund: When a failed waveform is detected, the oscilloscope displays the statistic results and outputs

a pulse; while at the same time, the beeper sounds regardless of the on/off status (refer to
the :SYSTem:BEEPer command) of the beeper.
Return Format
The query returns FAIL or FSO.
DS4000E Programming Guide
Range
{{1|ON}|{0|OFF}}
Range
{RUN|STOP}
Range
{FAIL|FSOund}
RIGOL
Default
0|OFF
Default
STOP
Default
FAIL
2-111