Remote Interface Configuration; Lan Configuration - Rigol MSQ7054 User Manual

RIGOL

Remote Interface Configuration

MSO7000/DS7000 series can communicate with the PC via the USB, LAN, or GPIB
(requiring to work with RIGOL's USB-GPIB interface converter) interface. Before
using the remote interfaces, configure the corresponding interface according to the
introductions in the following section.

LAN Configuration

Before using the LAN bus, use a network cable to connect the oscilloscope to your
local area network. The network interface of the oscilloscope is on the rear panel.
Press Utility  IO  LAN to open the LAN Settings interface, as shown in the
following figure. You can view the current network settings and configure the
network parameters.
Network Status
Current IP Config.
Type
MAC Address
VISA Descriptor
IP Config. Type
Network Parameters
Web Control
Network Status
Different prompts will be displayed according to the current network connection
status.
Network Config Succeeded!

Acquiring IP...

IP Conflict!

Disconnected!

DHCP Config Failed!

Read Status Fail!

19-2
Chapter 19 System Utility Function Setting
Figure 19-1 Network Connection Setting Interface
MSO7000/DS7000 User Guide