System Commands; System:aoutput - Rigol DS4000E Series Programming Manual

RIGOL

:SYSTem Commands

Command List:

:SYSTem:AOUTput


:SYSTem:AUToscale

:SYSTem:BEEPer

:SYSTem:DATE

:SYSTem:ERRor[:NEXT]?

:SYSTem:ETIMpedence

:SYSTem:EXPand

:SYSTem:GAMount?

:SYSTem:GPIB

:SYSTem:LANGuage

:SYSTem:OPTion:INSTall

:SYSTem:OPTion:UNINSTall

:SYSTem:PON

:SYSTem:PSTatus

:SYSTem:RAMount?

:SYSTem:RCLOck

:SYSTem:RESet

:SYSTem:SETup

:SYSTem:SSAVer:TIME

:SYSTem:TIME

:SYSTem:UDEVice

:SYSTem:VERSion?

:SYSTem:AOUTput
Syntax
:SYSTem:AOUTput <aoutput>
:SYSTem:AOUTput?
Description
Sets or queries the type of the signal output from the [Trig Out/Calibration] connector on the rear
panel.
Parameter
Name Type
<aoutput> Discrete
Remarks
TOUT: indicates that each time the oscilloscope triggers, a signal that can reflect the current capture

rate of the oscilloscope will be output from the [Trig Out/Calibration] connector on the rear panel.
QEDGe: indicates that a fast edge signal whose rise time is 500 ps will be output from the [Trig

Out/Calibration] connector on the rear panel. The signal can be used for the self-calibration of the
oscilloscope.
GND: indicates that a ground level will be output from the [Trig Out/Calibration] connector on the rear

panel.
PFAil: indicates that when a failed waveform is detected by the oscilloscope, a pulse will be output

from the [Trig Out/Calibration] connector on the rear panel.
Return Format
The query returns TOUT, QEDG, GND, or PFA.
2-180
Range
{TOUT|QEDGe|GND|PFAil}
Chapter 2 Command System
Default
TOUT
DS4000E Programming Guide