Mask:enable; Mask:failed; Mask:mdisplay - Rigol DS4000E Series Programming Manual

RIGOL
When sending the command, directly place the data stream after the command string, then complete

the whole sending process in one time. When reading the data stream, ensure that there is enough
buffer space to receive the data stream; otherwise, errors might occur in reading the program.

:MASK:ENABle

Syntax
:MASK:ENABle <bool>
:MASK:ENABle?
Description
Enables or disables the pass/fail function; or queries the on/off status of the pass/fail function.
Parameter
Name Type
<bool> Bool
Remarks
The pass/fail test function cannot be enabled in any of the following conditions:
In the X-Y horizontal time base mode (refer to the :TIMebase:MODE command);

In the Roll horizontal time base mode;

In the Y-T horizontal time base mode and when the horizontal time base is set to 200 ms/div or slower

(refer to the :TIMebase[:MAIN]:SCALe command; in this case, the instrument enters the "Slow
Sweep" mode);
When the waveform recording function is enabled (refer to the :FUNCtion:WRMode command);

When no analog channel (CH1 to CH4) is turned on (refer to the :CHANnel<n>:DISPlay command).

Return Format
The query returns 1 or 0.

:MASK:FAILed?

Syntax
:MASK:FAILed?
Description
Queries the number of failed frames in the pass/fail test results.
Return Format
The query returns an integer.

:MASK:MDISplay

Syntax
:MASK:MDISplay <bool>
:MASK:MDISplay?
Description
Turns on or off the display of the statistic information of the pass/fail test results; or queries the on/off
status of the display of the statistic information of the pass/fail test results.
2-110
Range
{{1|ON}|{0|OFF}}
Chapter 2 Command System
Default
0|OFF
DS4000E Programming Guide