Drive Chain; Adjustment Of The Tension On The Drive Chain; Replacement Of The Drive Chain - Kodak M35 Service Manual

Drive Chain

Adjustment of the Tension on the Drive Chain

[1] Check that the DRIVE CHAIN is wet with
solution.
[2] Check that the RACK ASSEMBLY is at
approximately the same temperature as the
solutions in the tanks, to assure that the
DRIVE CHAIN is the correct length.
[3] Loosen the 4 HOLDING SCREWS.
[4] Hold the RACK ASSEMBLY above the work
surface until gravity tightens the DRIVE
CHAIN around the TURNAROUND
ASSEMBLY.
[5] Rotate the DRIVE GEAR one full turn.
[6] Tighten the 2 HOLDING SCREWS on the
drive side first.
[7] Place the RACK ASSEMBLY on the work
surface.
[8] Rotate the ADJUSTING SCREWS until the
distance between the SIDE PLATE of the
RACK and the SIDE PLATE of the
TURNAROUND ASSEMBLY on the non-drive
side is equal to the distance between the
2 SIDE PLATES on the drive side.
[9] Tighten the 2 HOLDING SCREWS on the
non-drive side.
Remove LINKS from the DRIVE
CHAIN if necessary to provide the
correct length. See steps 1 - 5.

Replacement of the Drive Chain

[1] To open the existing DRIVE CHAIN, insert a
screwdriver under the HOOKS of a LINK.
Rotate the screwdriver if necessary.
[2] Attach the new DRIVE CHAIN to the existing
DRIVE CHAIN with the HOOKS in the
direction of travel and the openings of the
LINKS outward. See the illustration.
2-8
NOTE
TURNAROUND
ASSEMBLY
HOOK
[3] Pull the existing DRIVE CHAIN through the
RACK ASSEMBLY until the new DRIVE
CHAIN is in the correct position.
[4] Disconnect the existing DRIVE CHAIN from
the new DRIVE CHAIN.
[5] Connect the ends of the new DRIVE CHAIN.
[6] Do the Drive Chain Adjustment above.
SIDE PLATE
DRIVE
GEAR
ADJUSTING
SCREW (4)
HOLDING
SCREW (4)
LINK

DRIVE CHAIN

H112_0109CCA
H112_0109CA
981777