Print Quality Adjustment - MUTOH ValueJet VJ-1638UR Operation Manual

Print quality adjustment

It is used for optimizing the quality of image prints.
Adjustment methods for this printer are as follows.
Adj. Print 1:
Adj. Print 2:
Note
• When newly setting or changing the user type setting after adjusting Standard adjust print, make sure to adjust print.
• When changing the print mode after performing standard head adjustment, make sure you adjust print head.
• Since all print modes are adjusted at once after performing Custom adjust print, adjust print is not required even after changing the print mode. When
specifying a print mode for RIP software, etc, that is different from the mode set in the usertype setting, perform Custom head adjustment and check all
patterns (A to F), and then adjust any patterns that are misaligned beforehand.
• Print quality may improve by head adjustment in the following situations:
For adjustment procedure, see
Print quality is poor when using the uni-direction print mode.
Print quality does not improve even after performing print quality adjustment
• After you have performed head adjustment, make sure you perform print quality adjustment.
There may be misalignment caused by head adjustment.
40

Print quality adjustment

Standard
Custom
"Head adjustment" P. 38
Adjusts only the print mode used by the current user definition.
When you have adjusted the print mode using Standard, make the
resolution, pass count, and print direction of the print mode on the RIP
side equal to those of the userdefined print mode.
Allows you to adjust also a print mode other than the print mode used by
the current user definition.
This method optimizes print quality even if the print mode on the RIP side
is different from the user-defined mode.
"Details of print mode" P. 58